Clarion Community Help

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
| **Navigation:**  [[clarion.htm|Clarion.Net (Clarion#)]] > [[clarion net faqs.htm|Clarion.NET FAQs/Troubleshooting]] > WinForms >====== Adding .NET Controls and Components to the Designer ====== | [[winforms troubleshooting.htm|{{btn_prev_n.gif|Previous page}}]][[clarion net faqs.htm|{{btn_home_n.gif|Return to chapter overview}}]][[adding an ocx control to the design environment.htm|{{btn_next_n.gif|Next page}}]] |
|  ||

Here are the general steps for adding new controls and components to the Clarion.NET Designers.

1.Start the IDE and open a project. Activate the Form design window. Right click on one of the tabs in the **Toolbox** pad and choose **Configure Sidebar**.

2.The left-hand pane displays a list of the available categories. You can add your new component to one of the existing categories or create a new one. To add a new Category, click the **New** button in the lower left corner.

3.Click the **Add Components** button. Select the **Custom** tab. Click the button just to the right of the **File Name** textbox. Use the Open explorer window and select the assembly file (DLL) containing your new components.

4.The file path and name are now displayed in the **File Name** textbox. Click the **Show Components** button. The components should now be displayed in the right-hand pane. Click the **OK** button.

5.The new component is now available on the **Category** tab you selected. Before you can place an instance of the control on your Form, you may have to change the Form's **Font.Unit** property to //Point// in the **Property** pad.

6.You can now place an instance of the control on your Form and have access to the properties and events in the Property pad.

Finally, make sure to add the newly added assembly to the References node in the target Project.